Draft Paper

When referring to a 'logical' network we are talking about the logical addressing used to describe the network itself or the networks it connects to.

A logical network layout clearly shows the IP Addresses associated with each part of the network. In most cases, the logical network is a simple Class C network such as 192.168.0.0 with the default subnetmask of 255.255.255.0. This network allows up to 254 hosts to be connected directly to it without the need of any routing.

One of the most important steps when designing a logical network is the future growth and expansion, a point that most people tend to overlook and face problems such as running out of available IP Addresses. When I design a network, I always leave room for an addition 50-60% growth of its current size. In practice, this means that if you asked me to design a network with 60 workstations, I'll design it with at least 100 workstations, giving you 40 extra IP Addresses. Of course, if we are talking about one or two networks at most, then you simply assign as I previously said, one full Class C network.

In addition, it's generally a good practice to leave the first 10 or 20 IP Addresses for critical network devices/hosts, such as gateways, routers, switches, servers and printers, and hand out the rest of the remaining IP's to the users.

Coming to the second part of your question, the Physical design, it refers to the actual layout of the physical part of our network. This includes the cables, switches, workstations etc. A physical layout/map usually involves a diagram of the actual floor the way it would be seen if you were on the ceiling, looking down towards to the floor.

The classical physical design of most networks involve a central rack located in a computer room or a restricted access room (you can check my rack out if you like!: www.firewall.cx/about-chris-network.php) where all wiring from the walls terminate and connect at the back of a patch panel. From the front side of the patch panel, UTP cables run directly to the switch, interconnecting all network devices.

This topology is also known as a "star" topology since all devices connect to a central hub/switch:

PC1 PC2 PC3

| /

| /

| /

| /

/ |

/ |

/ |

PC4 PC5 PC6

The physical design also defines the type of cable used to connect all devices, e.g Cat 5, Cat 5e or Cat 6, and the distances the devices will have from the switch.

The pretty much covers it all! If you require further information about physical and logical networks, you can search on the Internet and I'm sure you will be overwhelmed by the results!

Before we take a look at why physical and logical network designs are important, let's clarify exactly what they are.

A physical layout of the network shows the physical location of and the connections between devices participating on the network. In such diagrams, workstations are usually represented with small computer icons, servers with full tower cases, and switches and other similar devices are displayed as small rectangular boxes with their RJ-45 ports in the front (sometimes, switches are displayed without ports, depending on the angle at which we are viewing the network on the page).

A logical layout shows all logical aspects of the network. This includes logical networks, assigned IP addresses to various hosts and devices, routing tables and a lot more. In logical diagrams, there is very little interest in the actual interfaces and physical cables, so these details are usually omitted.

So

...